English
Login
3D printers
Materials
Parts & Accessories
Software
3D Models
Applications
Community
Help
Academy
Blog
Company
Support
Original Prusa MINI
Printer maintenance
How to replace an extruder motor (MINI/MINI+) | Begin assembly
1. Begin assembly
Step 1 of 25 (Chapter 11 of 23)
Fullscreen mode
Contents
Comments
Difficulty
Moderate
Available languages
Begin assembly
Contents
Printer maintenance
How to replace a M.I.N.D.A. sensor (MINI)
How to replace a print fan (MINI)
How to replace a hotend PTFE tube (MINI/MINI+)
How to replace a heatsink (MINI/MINI+)
How to replace a Buddy control board (MINI)
How to access and clean the extruder-pulley (MINI/MINI+)
How to update firmware (MINI/MINI+)
How to replace a print head PTFE tube (MINI/MINI+)
Height adjustment of M.I.N.D.A./SuperPINDA sensor (MINI/+)
How to replace a heatbed (MINI/MINI+)
How to replace an extruder motor (MINI/MINI+)
Begin assembly
Introduction
Tools necessary for this guide
Preparing the printer
Opening the box with the electronics
Disconnecting the optical sensor (optional)
Disconnecting the extruder motor
Removing the bowden PTFE tube
Removing the extruder motor
Removing the extruder motor
Extruder surgery
Removing the extruder motor cable
Removing the pulley
New extruder motor - parts preparation
Extruder motor preparation
Installing the extruder motor
Assembling the extruder
Assembling the extruder
Mounting the extruder
Connecting the motor cable
Installing the filament sensor (optional)
Connecting the filament sensor (optional)
Covering the electronics
Mounting the bowden PTFE tube
It's done
How to replace SuperPINDA (MINI/MINI+)
How to replace bearings on the X-axis (MINI/MINI+)
How to replace bearings on the Y-axis (MINI/MINI+)
How to replace a heatbed set (MINI/MINI+)
How to replace a heatbed thermistor (MINI/MINI+)
How to replace a hotend thermistor (MINI/MINI+)
How to replace a hotend fan (MINI)
How to replace a hotend heater (MINI/MINI+)
How to replace a heaterblock/heatbreak (MINI/MINI+)
How to post-process the printed parts
How to trim PTFE tube - Original Prusa printers
Replacing the PEI sheet on the (MK3S/MK3/MK2.5S/MK2.5)
Comments
Log in
to post a comment
No comments
