English
Login
3D printers
Materials
Parts & Accessories
Software
3D Models
Applications
Community
Help
Academy
Blog
Company
Support
Original Prusa MINI
Printer maintenance
How to replace a heatsink (MINI/MINI+) | Begin assembly
1. Begin assembly
Step 1 of 26 (Chapter 4 of 23)
Fullscreen mode
Contents
Comments
Difficulty
Moderate
Available languages
Begin assembly
Contents
Printer maintenance
How to replace a M.I.N.D.A. sensor (MINI)
How to replace a print fan (MINI)
How to replace a hotend PTFE tube (MINI/MINI+)
How to replace a heatsink (MINI/MINI+)
Begin assembly
Introduction
Tools and fasteners necessary for this guide
Protecting the heatbed
Disassembly of fittings
Removing the hotend PTFE tube
Removing the textile sleeve
Disassembly of the hotend
Removing the hotend fan
Removing the print fan
Removing the heatsink
Heatsink parts - preparation
Heatsink installation
Print fan installation
Hotend fan installation (new design)
Hotend fan installation (old design)
Applying the thermal paste
Removing the lower fitting
Hotend installation
Covering the cables (new design)
Covering the cables (old design)
Hotend PTFE tube installation
Hotend PTFE tube installation
Hotend PTFE tube installation
Hotend PTFE tube installation
M.I.N.D.A./SuperPINDA sensor height adjustment
How to replace a Buddy control board (MINI)
How to access and clean the extruder-pulley (MINI/MINI+)
How to update firmware (MINI/MINI+)
How to replace a print head PTFE tube (MINI/MINI+)
Height adjustment of M.I.N.D.A./SuperPINDA sensor (MINI/+)
How to replace a heatbed (MINI/MINI+)
How to replace an extruder motor (MINI/MINI+)
How to replace SuperPINDA (MINI/MINI+)
How to replace bearings on the X-axis (MINI/MINI+)
How to replace bearings on the Y-axis (MINI/MINI+)
How to replace a heatbed set (MINI/MINI+)
How to replace a heatbed thermistor (MINI/MINI+)
How to replace a hotend thermistor (MINI/MINI+)
How to replace a hotend fan (MINI)
How to replace a hotend heater (MINI/MINI+)
How to replace a heaterblock/heatbreak (MINI/MINI+)
How to post-process the printed parts
How to trim PTFE tube - Original Prusa printers
Replacing the PEI sheet on the (MK3S/MK3/MK2.5S/MK2.5)
Comments
Log in
to post a comment
No comments
