Deutsch
Login
3D-Drucker
Materialien
Teile & Zubehör
Software
3D Modelle
Anwendungen
Community
Hilfe
Akademie
Blog
Unternehmen
Support
Original Prusa i3 MK2S
Original Prusa i3 MK2S Bausatz
2. Y-axis assembly | Get the necessary tools
1. Get the necessary tools
Step 1 of 45 (Chapter 2 of 9)
Inhalt
Kommentare
⬢
13/17mm spanners
⬢
3.6mm flathead screwdriver
⬢
Needle-nose pliers
⬢
2.5 and 1.5mm Allen key
Loading...
Weiter
Inhalt
Original Prusa i3 MK2S Bausatz
1. Einleitung
2. Y-axis assembly [Übersetzung in Arbeit]
Get the necessary tools
3D printed parts
Assemble the Y-axis rods
Assemble the Y-axis stage rear
Assemble the Y-axis stage front
Fully assemble the Y-axis stage
Preparing for Y-axis stage
Tighten the sides to the y-axis stage
VIDEO for step 8
Identifying the length of rods
Adjust the length of the Y-axis stage
VIDEO for step 11
Marker identification
Correct bearing orientation
Assemble the Y-carriage
Tighten Y-carriage u-shaped bolts
Assembly of the Y-idler
Tighten the Y-idler
Y-motor-distance assembly
Y-axis motor
Adding the Y-axis endstop
Tightening the Y-axis endstop
Y-axis endstop cable guide
Assemble the Y-belt holder
Assemble the Y-carriage rods
Assemble the Y-axis stage
Tighten the zipties on the Y-axis stage
Assemble the belt on the Y-axis, part 1
Assemble the belt on the Y-axis, part 2
Loosening the motor
Assemble the Y-motor pulley
The Y-axis belt placement
Tighten the Y-axis belt, part 1
Tighten the Y-axis belt, part 2
Tensioning the belt
Video for steps 29-35
Adjust the Y-idler
Adjust the Y-motor-mount part
Tighten the screws in the pulley
The Y-axis stage cable management
Levelling the Y-axis
Secure the axis feet
The Y-Endstop check
Double check the Y-carriage!
All done!
3. Zusammenbau der X-Achse
4. Zusammenbau der Z-Achse
5. Zusammenbau des Extruders
6. Zusammenbau der LCD-Anzeige
7. Montage von Netzteil und Heizbett
8. Zusammenbau der Elektronik
9. Letzte Kontrolle vor dem Start
Kommentare
Einloggen
um einen Kommentar zu schreiben
Keine Kommentare
