• Čeština
  • Español
  • Italiano
  • Deutsch
  • Polski
  • Français
  • 日本語

Per model settings

This article is also available in following languages: 

With PrusaSlicer, you can print multiple models at once, each with slightly different settings. For example, with different infill or layer height. 

Right-click (Advanced mode) on a model and pick either:

  • Infill
  • Layers and perimeters
  • Support material

In the Expert mode, an additional Add settings option is available that lets you adjust settings such as speed, extrusion width, infill/perimeter overlap and more.

Alternatively, you can right-click on the editing icon in the Object list.

A new window will appear in the right panel called Object settings to modify. Changing these settings will affect only the relevant object and its instances. You can remove the settings overwrite by clicking on the red cross icon. When you do so, the global settings will once again be applied.


Was this article helpful?


Still have questions?

Still have questions?

If you have a question about something that isn't covered here, check out our additional resources.
And if that doesn't do the trick, you can send an inquiry to [email protected] or through the button below.

Contact us