EN
  • Čeština
  • Español
  • Italiano
  • Deutsch
  • Polski
  • Français
Login

Multi material painting

This article is also available in following languages: 
CSDEESFRITPL

Preparing models for multi-material FDM prints used to be a fairly complicated and time-consuming process. Starting with PrusaSlicer 2.4, coloring an object for multi-material printing requires just a handful of bucket fills and brushstroke operations.

Painting tools

Brush

Similar to the support or seam painting tool. Hold down your left-mouse button to paint with the primary color, the right mouse button to paint with the secondary color.

Smart fill

With the Smart fill tool selected, as you hover the mouse above the model, you get a real-time preview of the automatically detected region to paint. The paint fills a region below the mouse cursor up to a sharp edge, with the threshold angle adjustable.  

Bucket fill

Replace a patch of one color with another.

Video showcase

Color selection

The combo boxes First color and Second color in the panel allow mapping different extruders to the left and right mouse buttons. The number and color of the selected extruder are shown for clarity. The color that is used for visualization can be overridden by clicking the colored square next to the selected extruder. This visualization color is not saved anywhere and will be lost when the application closes.

Segmenting colors

During slicing, the painted regions are cleverly extended inwards, giving the different colors/polymers the best chance of binding together.

The object surface is segmented into patches of the same material and the patches are extended inwards. The regions painted at the top resp. bottom surfaces are extended by the number of top_solid_layers resp. bottom_solid_layers (configurable in Print Settings - Layers and Perimeters). The regions painted at the side walls are expanded inwards up to maximum mmu_segmented_region_max_width (which is a new configuration parameter accessible in Print Settings->Multiple Extruders->Advanced).

The painting only affects the slicing result, the model itself is not altered and the colored "parts" cannot be exported separately.

Notes

Please note that thin features are not printable with FDM technology, thus for example painting a thin wall with two distinct colors will not make the thin wall printable. Such thin non-printable regions created during segmentation are thus detected and merged with the neighboring region, changing its color. PrusaSlicer will print thinner features with "detect thin walls" enabled, thus it is advised to try to enable "detect thin walls" if painting over thin features.

There are two extra limitations arising from technical reasons:

The multi-material painting is limited to 16 extruders. If your printer uses more extruders, only the first 16 will be available in the painting tool.

Multi-material painting cannot be combined with XY size compensation. The XY size compensation will be ignored during slicing if the object is also multi-material painted. The user is informed by notification in both cases.

Examples of painted models

Was this article helpful?
This action is available only to registered users. Please log-in.

Comments

Please sign in before adding a comment.
0
Still have questions?

Still have questions?

If you have a question about something that isn't covered here, check out our additional resources.
And if that doesn't do the trick, you can send an inquiry to info@prusa3d.com or through the button below.