Invalid FW size on USB #13603 (MK4) #21603 (MK3.9) #23603 (MK3.5)

Relevant for:

MK4 MK3.9 MK3.5

Last updated 8 days ago

This article is also available in following languages:

What happened?

While flashing firmware to your Original Prusa MK4, MK3.9, or MK3.5, an error might occur, and the screen will display the following message: "Firmware file has invalid size! Check the file on the USB drive and try again".

Error name: Invalid FW size on USB

Error code: #13603 (MK4) #21603 (MK3.9) #23603 (MK3.5)

This error can happen if the bootloader file is edited, or if the USB is removed from the computer before the end of the file transfer.

How to fix it?

Delete the firmware file from the USB drive, and download it again. Transfer the file to the USB drive. Make sure to unmount the drive from your operating system before physically removing it. This will prevent the USB drive from being removed too early.

Insert the USB drive back into the printer and reboot the printer using the reset button directly next to the knob to initiate the flashing procedure. In case the procedure does not start, reboot the printer again by pressing the same reset button, and while the printer is booting up, press once the rotating knob.

If the issue persists, the problem might be in the USB flash drive. Find any other USB drive in your household, make sure it is formatted to FAT32, copy both firmware files, and repeat the previously described procedure.

Are you still having issues? Contact our support team and let them know, that you have tried to fix the issue with these instructions. We will take it from there.

Was this article helpful?

Easy to understand

Solved my problem

Other reason

Comments

Still have questions?

If you have a question about something that isn't covered here, check out our additional resources.
And if that doesn't do the trick, you can send an inquiry to [email protected] or through the button below.