EN
  • Čeština
  • Español
  • Italiano
  • Deutsch
  • Polski
  • Français
  • 日本語
Login

Get support

This article is also available in following languages: 
CSPLESDEITFRJA

The search bar on top of this site searches the entire PrusaSlicer documentation as well as assembly guides and related printer hardware troubleshooting guides. If neither has the answer to your problem, you can try several things:

PrusaSlicer forum on prusaprinters.org

The PrusaSlicer forum is an active community of PrusaSlicer users. You can post your problem there and discuss it with numerous expert users in the community.

Facebook groups

If you use Facebook, there are several active groups that are quick to help you with your problem:

Report an issue - Github

Even though the PrusaSlicer team has 7 full-time developers and several active community contributors, going through reported issues and feature requests take a considerable amount of time. Before you report a new issue, please make sure you've exhausted other options.

There is a good chance that the issue is already reported, you can check the list of reported issues here.

Finally, you can create a new issue here.

 
Was this article helpful?

Comments

Still have questions?

Still have questions?

If you have a question about something that isn't covered here, check out our additional resources.
And if that doesn't do the trick, you can send an inquiry to [email protected] or through the button below.

Contact us