1. 組み立てを始める

プリンターメンテナンス

• How to install the Nextruder V6 nozzle adapter (CORE One L)
• How to replace the Prusa Nozzle (CORE One L)
• How to replace a hotend assembly (CORE One L)
• How to replace the hotend fan (CORE One L)
• How to replace the side filament sensor (CORE One L)
• How to install the Advanced Filtration (CORE One L)
• How to replace the Buddy3D camera cable (CORE One L)
• How to replace a Hotend Heater (CORE One L)
• How to replace a Hotend Thermistor (CORE One L)
• How to replace Nextruder Filament Sensor (CORE One L)
• How to replace the print fan (CORE One L)
• How to replace the Accelerometer (CORE One L)
• How to replace Hotend Heatsink (CORE One L)
• How to reverse the door orientation (CORE One L)
• How to replace Loveboard (CORE One L)
• How to replace a Hotend Thermistor (CORE One L)
• How to replace the White LED strip (CORE One L)
• How to pack CORE One L for return
• How to replace the heatbed fans (CORE One L)
• How to replace the heatbed (CORE One L) [進行中の翻訳]
  1. 組み立てを始める
  2. Introduction
  3. Tools necessary for this guide
  4. Preparing the printer
  5. Removing the Wi-Fi module
  6. Removing the electronics covers
  7. サイドカバーを取り外します
  8. ACケーブルを取り外します
  9. Removing the LED panel
  10. Disconnecting the LED panel
  11. Removing the heatbed cables
  12. Removing the cable sleeve
  13. Removing the heatbed part I
  14. Removing the heatbed part II
  15. Parts Preparation: Heatbed
  16. Mounting the new heatbed
  17. Securing the new heatbed
  18. Attaching the cable sleeve
  19. Parts preparation: zip ties
  20. Attaching the front zip tie
  21. Connecting the LED panel
  22. Attaching the LED panel
  23. Attaching the side zip ties
  24. ヒートベッドケーブルの接続
  25. Plugging in the heatbed cables
  26. サイドカバーを再取り付けします
  27. Covering the electronics
  28. Reattaching the Wi-Fi module
  29. Powering the printer & selftest
  30. Done
• How to replace the AC box (CORE One L)