JA
  • English
  • Čeština
  • Español
  • Italiano
  • Deutsch
  • Polski
  • Français
Login

PrusA64 mainboard electronics wiring (SL1)

Relevant for:
Last updated 3 years ago
This article is also available in following languages: 
ENCSPLDEESITFR

With the technology used in MSLA 3D printing, the Original Prusa SL1 has a different mainboard arrangement compared to our FFF printers. It uses two boards instead of one:

  • PrusA64 mainboard with A64 ARM CPU and graphics driver for both screens
  • Motion controller board (MC) with drivers controlling all movements (tilt and tower)

Electronics wiring

For the exact order of the wiring and cable management, we recommend seeing the electronics section of the assembly manual.

If you are replacing the PrusA64 board, please see our guide How to replace the A64 board (SL1) [進行中の翻訳].

Was this article helpful?

Comments

Still have questions?

Still have questions?

If you have a question about something that isn't covered here, check out our additional resources.
And if that doesn't do the trick, you can send an inquiry to [email protected] or through the button below.

Contact us