1. Begin assembly

Printer maintenance

• How to replace a hotend thermistor (MK3S/MK3S+)
• How to replace a print fan (MK3S/MK3S+)
• How to replace a hotend (MK3S/MK3S+)
• How to replace an IR-sensor (MK3S/MK3S+)
• How to replace a P.I.N.D.A. sensor (MK3S)
  1. Begin assembly
  2. Introduction
  3. Tools necessary for this guide
  4. Preparing the printer
  5. Disconnecting of the P.I.N.D.A. sensor
  6. Removing the x-carriage-back
  7. Removing the P.I.N.D.A. sensor
  8. New P.I.N.D.A. sensor - parts preparation
  9. Installing the new P.I.N.D.A. sensor
  10. Cable guiding
  11. Mounting the x-carriage-back
  12. Tightening the textile sleeve
  13. Tightening the textile sleeve
  14. Connecting the P.I.N.D.A. sensor
  15. Guiding the textile sleeve
  16. Cable management
  17. P.I.N.D.A. adjustment
  18. P.I.N.D.A. adjustment
  19. It's done
• How to replace SuperPINDA (MK3S/MK3S+)
• How to replace a hotend heater (MK3S/MK3S+)
• How to replace a heatbreak/heatsink/heaterblock (MK3S+/MK3S/MK2.5S/MMU2S)
• How to trim PTFE tube - Multi Material
• How to post-process the printed parts
• How to replace a heatbed thermistor (MK3S+/MK3S/MK2.5S/MK2S)
• How to replace PSU on MK3 printers
• How to replace a hotend PTFE tube (MK3S+/MK3S/MK2.5S/MMU2S)
• How to replace a hotend thermistor (MK2S)
• How to trim PTFE tube - Original Prusa printers
• Maintenance tips
• Replacing the PEI sheet on the (MK3S/MK3/MK2.5S/MK2.5)