1. Comenzar el montaje

Mantenimiento de la impresora

• Buddy3D Camera for CORE One Installation
• Como reemplazar la boquilla Prusa (CORE One)
• Cómo invertir la orientación de la puerta (CORE One)
• Embalaje de la Prusa CORE One para devolución - Material de Embalaje Original
• How to install Advanced Filtration (CORE One)
• Embalaje de la Prusa CORE One para devolución - Material de Embalaje Personalizado
• How to replace the xBuddy board (CORE One) [Traducción en desarrollo]
  1. Comenzar el montaje
  2. Introduction
  3. Tools necessary for this guide
  4. Important: Electronics protection
  5. Printer Preparation (Part 1)
  6. Printer Preparation (Part 2)
  7. Back Cover Removal (Part 1)
  8. Back Cover Removal (Part 2)
  9. xBuddy Cover Removal
  10. NFC Antenna Cover Removal
  11. Cables Disconnection
  12. Cables Disconnection 2
  13. Cables Disconnection 3
  14. Wi-Fi Cover Removal
  15. Wi-Fi Removal
  16. xBuddy Removal
  17. xBuddy Parts Preparation
  18. Thermal Pad Application
  19. xBuddy Installation
  20. Wi-Fi Installation
  21. Wi-Fi Cover Installation
  22. Power Cables Connection
  23. Zip-Tie Installation
  24. Extension Cable Connection
  25. Power Cables Connection 2
  26. PE Cable Connection
  27. Cables Connection 1
  28. Cables Connection 2
  29. Cables Connection 3
  30. Cables Connection 4
  31. Cables Connection 5
  32. Wiring Check
  33. xBuddy Cover Installation
  34. Rear Cover Installation
  35. Turning the Printer On
• How to replace a hotend assembly (CORE One)
• Cómo instalalar el Adaptador Nextruder a boquilla V6 (CORE One)
• Cómo reemplazar el sensor de la puerta (CORE One)
• How to replace the side filament sensor (CORE One)