1. Tools necessary for this chapter

Ensamblaje del Kit de Prusa CORE One+

• 1. Introduction
• 2. Base assembly
• 3. Back assembly
• 4. Heatbed assembly
• 5. CoreXY assembly
• 6. Nextruder assembly
• 7. Bodywork & Electronics [Traducción en desarrollo]
  1. Tools necessary for this chapter
  2. Front profiles: parts preparation
  3. Installing the front right profile
  4. Installing the front left profile
  5. Perfiles superiores: preparación de las piezas
  6. Assembling the top profiles I.
  7. Assembling the top profiles II.
  8. Aligning the top profiles
  9. Installing the top profiles
  10. CoreXY fixing screws: parts preparation
  11. Fixing the CoreXY assembly
  12. Side sensor base: parts preparation
  13. Assembling the side sensor base
  14. Probando la palanca
  15. Montaje del interruptor
  16. IR Sensor: parts preparation
  17. Connecting the IR sensor
  18. Installing the IR sensor
  19. Installing the side sensor cover
  20. Side filament sensor: parts preparation
  21. Installing the side filament sensor
  22. Guide the filament sensor cable
  23. Connecting the side filament sensor
  24. NFC Antenna: parts preparation
  25. Applying the adhesive film
  26. Installing the NFC Coil
  27. Connecting the NFC Coil
  28. Comprobación del cableado
  29. Preparing the electronics cover
  30. Installing the electronics cover
  31. Nota Cámara Buddy3D
  32. xBuddy cover: parts preparation
  33. Installing the xBuddy cover
  34. Installing the rear cover
  35. Right side: parts preparation
  36. Instalando el puck del soporte de bobina
  37. Right handle: parts preparation
  38. Instalando la presilla
  39. Montando el asa
  40. Fixing the right side
  41. Left side: parts preparation
  42. Installing the left side
  43. Momento Haribo
  44. Listo
• 8. Trim, Door & xLCD
• 9. Calibration & First run
• Lista de cambios del manual