⬢Plug-in the printer. If display is on, everything is fine ;-)
⬢Notice the squished filament line around the PRUSA logo. This is the right amount of compression for the first layer.
⬢Prepare the printbed.
DE
Login- English
- Home
- Plus 1.75 mm
- Montageanleitungen
- Original Prusa i3 Plus 1.75 mm Bausatz Montage
- First print i3 Plus LCD/SD
First print i3 Plus LCD/SD
Menu
- Original Prusa i3 Plus 1.75 mm Bausatz Montage
- Calibrate i3 Plus LCD/SD
- Introduction
- First print i3 Plus LCD/SD
- 1. Plug in the printer
- 2. Spool holder
- 3. Preheat the printer
- 4. Filament change
- 5. Clean the nozzle
- 6. Start the print
- 7. Check the first layer
First print i3 Plus LCD/SD
Relevant für:
Zuletzt aktualisiert 2 years ago Schwierigkeit
Mittel Schritte
7 Verfügbare Sprachen
⬢Snap the filament holder arms on the printer as seen on picture.
⬢Put the filament spool in by spreading the arms a bit.
⬢Filament must go towards you on the top side.
⬢Check if the filament is not coming out of the sides of the spool, if so, snip it.
⬢Preheat for ABS first as we test the printer with ABS. For later prints you can use preheat for PLA.
⬢Wait for the printer to heat up.
⬢On heated printer, grab the filament poking out of the extruder and with your other had rotate the big gear counter-clockwise until it completely comes out.
⬢Insert the end of the material into the hole and push while rotating the big gear clockwise until you see a little extrusion at the nozzle tip.
⬢Always check if the filament has nice sharp edge on the end for smooth insertion.
⬢This can be done with software, but by using your hand you can easily feel if the filament extrudes smoothly.
⬢Clean the nozzle before printing from any extrusion. I used the test logo print.
⬢In the menu choose Print from SD and PRUSA.gcode
⬢Printer will make a thick line on the side. This equalises the flow of plastic.
⬢Then printer will print so-called 'skirt' around. If it is nicely squished, you've done your calibration right!
⬢First layer is cruical so always watch the printer if the first layer is printed correctly.
War diese Anleitung hilfreich?
Kommentare
Sie haben noch Fragen?
Wenn Sie eine Frage zu etwas haben, das hier nicht behandelt wird, sehen Sie sich unsere zusätzlichen Ressourcen an.
Und wenn das nicht ausreicht, können Sie über die Schaltfläche unten oder an die [email protected] eine Anfrage senden.