1. Začít s montáží

Údržba tiskárny

• Jak naistalovat Nextruder V6 adaptér trysky (CORE One L)
• Jak vyměnit trysku Prusa (CORE One L)
• How to replace a hotend assembly (CORE One L)
• Jak vyměnit ventilátor hotendu (CORE One L)
• How to replace the side filament sensor (CORE One L)
• How to install the advanced filtration (CORE One L)
• How to replace a Hotend Heater (CORE One L)
• How to replace a Hotend Thermistor (CORE One L)
• How to replace Nextruder Filament Sensor (CORE One L)
• How to replace the print fan (CORE One L)
• How to replace the Accelerometer (CORE One L)
• How to replace Hotend Heatsink (CORE One L)
• How to reverse the door orientation (CORE One L)
• How to replace Loveboard (CORE One L) [Překládá se]
  1. Začít s montáží
  2. Introduction
  3. Tools Required
  4. Printer Preparation
  5. Printer Preparation 2
  6. Top Cover Removal
  7. Heatbed Protection
  8. Nextruder Cover Removal
  9. Hotend Disconnecting
  10. Hotend Assembly Removal
  11. PTFE Disconnection
  12. Cover Right Removal
  13. Extruder Disconnecting
  14. Extruder Removal
  15. Print Head Disassembly
  16. Print Head Disassembly 2
  17. Loveboard Removal
  18. Loveboard Preparation
  19. Loveboard Installation
  20. Print Head Assembly
  21. Print Head Assembly 2
  22. Extruder Installation
  23. Fan Installation
  24. Extruder Connection
  25. Extruder Connection 2
  26. Cover Right Installation
  27. LoveBoard Connection Check
  28. PTFE Installation
  29. Hotend Assembly Installation
  30. Nozzle Check
  31. Hotend Connection
  32. Hotend Cables Guidance
  33. Cover Left Attachment
  34. Top Cover Attachment
  35. Power Up
  36. Final check
• How to replace a Hotend Thermistor (CORE One L)