1. Začít s montáží

Údržba tiskárny

• Jak naistalovat Nextruder V6 adaptér trysky (CORE One L)
• Jak vyměnit trysku Prusa (CORE One L)
• How to replace a hotend assembly (CORE One L)
• Jak vyměnit ventilátor hotendu (CORE One L)
• How to replace the side filament sensor (CORE One L)
• How to install the advanced filtration (CORE One L)
• How to replace a Hotend Heater (CORE One L)
• How to replace a Hotend Thermistor (CORE One L)
• How to replace Nextruder Filament Sensor (CORE One L)
• How to replace the print fan (CORE One L)
• How to replace the Accelerometer (CORE One L)
• How to replace Hotend Heatsink (CORE One L)
• How to reverse the door orientation (CORE One L) [Překládá se]
  1. Začít s montáží
  2. Introduction
  3. Tools necessary for this chapter
  4. Removing the door panel
  5. Removing the hinges
  6. Magnet holders: parts preparation
  7. Installing the door magnets
  8. Door hinges: parts preparation
  9. Installing the inner hinges
  10. Installing the outer hinges
  11. Door panel: parts preparation
  12. Mounting the door panel
  13. Well done!
• How to replace Loveboard (CORE One L)
• How to replace a Hotend Thermistor (CORE One L)