• Čeština
  • Español
  • Italiano
  • Deutsch
  • Polski
  • Français

Tower endstop not reached #10114 (SL1/SL1S)

Relevant for:
Last updated 3 years ago
This article is also available in following languages: 

What happened?

The printer is displaying the message: Failed to reach tower endstop, please check that the tower motor is connected and repeat the action.

Error name: Tower endstop not reached

Error code: #10114

Issued when the printer cannot complete the tower movement during the initial calibration due to a connection error of the tower motor.

How to fix it?

Check the cable connection of the tower motor to the motion controller.

If the issue still happens after the cable is firmly connected, please contact Customer support.

Was this article helpful?



Still have questions?

Still have questions?

If you have a question about something that isn't covered here, check out our additional resources.
And if that doesn't do the trick, you can send an inquiry to [email protected] or through the button below.

Contact us