MMU Selftest failed #04315 (MMU)

Relevant for:

Last updated 4 months ago

This article is also available in following languages:

What happened?

After a startup / restart, the MMU unit performs a self-test. It checks if the main control board behaves correctly and if all the signals from the microcontroller get to the TMC motor drivers on the control board properly. If the MMU unit suspects the communication with the Selector motor TMC driver might not behave correctly, this error is shown.

How to fix it?

- Make sure your MMU3 unit is correctly assembled with the PD-board addon attached.

- Verify all the cables are in good condition and the connections are stable. Do not move, connect or disconnect the cables while the printer is on!

If the issue persists, contact support.

Was this article helpful?

Easy to understand

Solved my problem

Other reason

Comments

Still have questions?

If you have a question about something that isn't covered here, check out our additional resources.
And if that doesn't do the trick, you can send an inquiry to [email protected] or through the button below.