EEPROM I2C Receive Busy #13316 (MK4) #21316 (MK3.9) #23316 (MK3.5)

Relevant for:

MK4 MK3.9 MK3.5

Last updated 2 months ago

This article is also available in following languages:

What happened?

On the Original Prusa MK4/MK3.9/MK3.5, the I2C bus is used for the xBuddy board to communicate with other printer components. The components have different states, including a busy state: if this particular state occurs while data is being received by the xBuddy board, the printer will show the message: "HAL detected an I2C busy when receiving data via I2C."

Error name: EEPROM I2C Receive Busy

Error code: #13316 (MK4) #21316 (MK3.9) #23316 (MK3.5)

How to fix it?

Restarting the printer is expected to resolve the error, and this is not expected to occur again. In case a restart does not resolve it, please contact our customer support, we will take it from here.

Was this article helpful?

Easy to understand

Solved my problem

Other reason

Comments

Still have questions?

If you have a question about something that isn't covered here, check out our additional resources.
And if that doesn't do the trick, you can send an inquiry to [email protected] or through the button below.