Increasing PEI adhesion
In certain situations, you will need to achieve a better adhesion than usual. One such example could be printing a tall object with a small contact area on the print surface. Fortunately, PEI (polyethyleneimine) is a chemically resistant polymer, which enables you to apply various adhesion solutions without damaging it. Adhesion solutions are also useful for materials that would otherwise not stick to PEI - like Nylon.
Before you consider applying extra adhesion materials onto the bed, consider using the Brim option in Slic3r PE or PrusaControl which increases the surface area of the first layer.
You can easily turn this feature [on/off] in Prusacontrol and use the default settings. You can set the brim size manually in Slic3r PE by going into Print settings - Skirt and brim - Brim. Generally, it is advised to use at least 3mm brim to increase the adhesion.
You should consider using the brim option when printing:
- Tall objects with a small base.
- Multiple objects at once.
Glue is a great, easy to use tool to increase the adhesion. There is no special glue for 3D printing, you can use a basic glue stick. From our experience, it is only needed when printing:
- Other more exotic materials with lower adhesion
PEI can lose its adhesive powers after a couple of hundred hours. When you see models coming loose regularly, wipe the surface thoroughly with acetone to restore the adhesion.
For ABS prints, ABS juice can be used and later cleaned with pure acetone. Be very gentle when applying the juice and do so only when the bed is cold. Prints will attach very strongly.